Cut Function, Tcs (Ap 7.T) - Novexx Solutions AP 4.4 Service Manual

04/09 Rev. 5.01-02

Cut function, TCS (AP 7.t)

Problem
No function
Material is only
partially cut or not cut
at all
Cut next to recog-
nised gap
Cut offset to impres-
sion
[Tab. 11]Problems possibly caused by a TCS (if mounted).
SERVICE MANUAL
AP 4.4 – AP 5.4 – AP 7.t
Possible cause
Connector loose
TCS function not activated
Photoelectric switch
defective
Stepper motor or output
stage board defective
Cover open
Cover contact switch not
correctly adjusted
Setting of motor light barrier
Cutter blunt or dirty
Material problem
Gap detection
Cutter position incorrect
Solution
Plug in connector firmly.
Select and activate "TCS" setting for parame-
SYSTEM PARAMETER > Peripheral device
ter
Check and if necessary replace switch
Check and if necessary replace
Check and if necessary close cover
Check and if necessary adjust
Check light barrier or position of switch flag
and if necessary correct
Check and if necessary clean or replace
Only use approved materials
Check setting for parameter
PRINT PARAMETER > Cut position
sary correct the setting
Check and if necessary set
6
Fault Location
and if neces-