Launching The Software - ProDevice ASM120 Operating Manual

Operating Manual ProDevice ASM120 PPMS USER
4.

LAUNCHING THE SOFTWARE

Before connecting the device physically to the computer, you need to
properly configure the network adapter settings. Go to Control Panel ->
Network Connections.
Right-click on the local connection icon and select Properties. Then go
to the TCP/IP connection Properties. Check as shown in the figure (IP
Settings) "Use the following IP address" and enter the new settings: IP
Address - 192.168.0.190, Subnet mask - 255.255.255.0, Default gateway -
192.168.0.1.
Click OK to confirm changes after entering the data. Only now will the
computer correctly communicate with the device (over the Ethernet cross-
cable included with the product).
NOTE: The device communicates with the computer over port 5001 by
default. This port is not usually blocked on the computer; otherwise contact
this computer's Administrator.
Start the ProDevice ASM120 PPMS USER software by launching the
start file accessed via the program shortcut which is displayed after the
successful installation. The program can also be accessed via the Programs
www.prodevice.eu
ASM120
9