Usage; Initial Use - Beurer BM 28 Instructions For Use Manual

Connection for cuff
5
connector
Connection for mains part
7
9
START/STOP button
SET button
11
Information on the display
Time and date
12
Diastolic pressure
14
Cardiac arrhythmia
16
symbol
Pulse symbol
Memory display:
18
average value ( ),
morning ( ), evening
( ), memory space
number
20
Alarm function
22
User memory
Resting indicator
24
display
1
2
1
Risk indicator
6
Function buttons -/+
8
M memory button
10
Systolic pressure
13
Calculated pulse rate
15
Release air
17
Battery replacement
19
symbol
Risk indicator
21
Cuff position control
23

6. USAGE

6.1 Initial use

Inserting the batteries
• Remove the battery compartment cover on the back of
the device .
A
• Insert four 1.5-V AA (alkaline type LR6) batteries. Insert
the batteries, making sure the polarity is correct accord-
ing to the label
• Close the battery compartment cover.
If the symbol is displayed and does not disappear,
measurement is no longer possible. Replace all the batteries.
Once the batteries have been removed from the device, the
date and time must be set again. Any saved measured values
are retained.
Operation with the mains part
You can also operate this device with a mains part (not in-
cluded in delivery). However, before connecting the device
with the mains part, please ensure that you have removed
the batteries from the device. During mains operation, there
must not be any batteries in the battery compartment, as this
could damage the device.
• To avoid any potential damage, the device may only be
operated with a mains part that meets the specifications
described in the chapter "Technical specifications".
• Furthermore, the mains part must only be connected to
the mains voltage that is specified on the type plate.
27
.
A