Jeep Wrangler 1999 Electronic Service Manual page 1066

TJ
REMOVAL AND INSTALLATION (Continued)
(3) Position the front end lighting wire harness
into the retainers on the fender. Engage the retainers
to secure.
(4) Install the bolts attaching the fender to the
HCU tray reinforcement bracket.
(5) Install the bolts attaching the fender to the
cowl.
(6) If equipped, install the body side molding.
(7) Route the fog lamp (if equipped), park lamp
and side marker wire harness through the access
hole in the fender well. Seat the grommet
(8) Engage the headlamp wire connector.
(9) Install the HCU tray.
(10) Position the HCU on the support tray and
install the bolts.
(11) Install EVAP canister.
(12) Install horns.
(13) Engage horn wire connectors.
(14) Install the windshield washer reservoir.
(15) Connect the negative terminal on the battery.
BODY SIDE MOLDING
REMOVAL
(1) Remove the bolts from underside of the body
side molding (Fig. 15).
(2) Lift the molding upward to release it from the
molding support.
(3) Remove the molding support by drilling out the
rivets.
Fig. 14 Front Fender
INSTALLATION
(1) If removed, position the molding support on the
body and install the rivets.
(2) Place the upper edge of the molding over the
top of the molding support and slide it downward.
(3) Install the bolts into the underside of the body
side molding.
Fig. 15 Body Side Molding
BODY 23 - 19