Removing And Installing The Lamp Unit - Sharp Conference Series XG-V10WU Operation Manual

Replacing the Lamp

Removing and installing the lamp unit

CAUTION
• Be sure to remove the lamp cage by the handle. Be sure not to touch the glass surface of the lamp cage
or the inside of the projector.
• To avoid injury to yourself and damage to the lamp, be sure to carefully follow the steps below.
• Replace the lamp more safely by unplugging the power cord after turning off the main power.
1 Turn off the power.
Press POWER OFF. Wait until
the cooling fan stops.
or
4 Remove the lamp
cage.
Remove the securing screws
from the lamp cage. Hold the
lamp cage by the handle and
pull it horizontally towards you.
Securing screws
Securing screw
7 Turn off the main power again and
remove the lamp cage cover.
Turn off the main power switch
and slide the lamp cage cover
in the direction of the arrow (to
the open mark) on the back of
the projector.
• You need to reset lamp timer every time when replacing the lamp and confirm it to be reset on "Lamp Timer" menu.
2 Turn off the main
power.
Turn off the MAIN POWER
switch. (Unplug the power cord)
5 Attach the lamp cage cover
and turn on the main power.
Slide the lamp cage cover in the
direction of the arrow (to the
close mark) on the back of the
projector. Then turn on the MAIN
POWER switch.
8 Insert the new lamp
cage.
Press the lamp cage firmly into
the lamp cage compartment.
Fasten the securing screws.
Lamp 1
High angle view
3 Remove the lamp cage
cover.
Loosen the user service screw
that secures the lamp cage
cover on the back of the
projector. Then slide the cover in
the direction of the arrow (to the
open mark).
Press POWER ON on projector. LAMP
6
REPLACEMENT indicator flashes red.
Then press ENTER to reset lamp timer.
Press POWER ON, and then
press ENTER on the projector.
ON
ENTER
9 Attach the lamp cage
cover.
Slide the lamp cage cover in the
direction of the arrow (to the
close mark) on the back of the
projector. Then tighten the user
service screw.
Lamp 2
E-72