Removing And Installing The Lamp Unit - Sharp XR-10X-L Service Manual

Removing and Installing the
Lamp Unit
Warning!
Do not remove the lamp unit from the projec-
tor right after use. The lamp and parts around
the lamp will be very hot and may cause burns
or injury.
Info
Make sure that you remove the lamp unit by
the handle. Do not touch the glass surface of
the lamp unit or the inside of the projector.
To avoid injury to yourself and damage to the
lamp, make sure you carefully follow the steps
below.
Do not loosen other screws except for the
lamp unit cover and lamp unit.
1 1
Press STANDBY/ON on the pro-
jector or STANDBY on the re-
mote control to put the projector
into standby mode.
Wait until the cooling fan stops.
2
Disconnect the power cord.
Unplug the power cord from the AC
socket.
Leave the lamp until it has fully cooled
down (about 1 hour).
3
Remove the lamp unit cover.
Turn the projector over. Loosen the user
service screw (ı ) that secures the lamp
1
unit cover. Remove the lamp unit cover
(ˇ ).
2
XR-10X-L/XR-10S-L/XG-MB50X-L/XR-11XC-L/XR-HB007X-L
Optional
accessory
STANDBY/ON button
AC socket
1
1 – 10
Lamp unit
AN-XR10L2
(for XG-MB50X-L/
XR-11XC-L/XR-10X-L/
XR-10S-L/
XR-HB007X-L)
2
User service screw
(for lamp unit cover)