Table of Contents
Advertisement
2. Basic Installation
2.1 Hard Disk Installation
You can install two 3.5" HDDs inside the DVR for recording videos. The maximum capacity of
each HDD is 8TB.
1. Make sure the DVR is power-off.
2. Unscrew the eight housing screws (4 on the rear panel, 2 on the left and right side each). To
remove the housing cover from the DVR, push the cover backward and then lift it.
3. Find the SATA cable and power cable inside the DVR, connect the SATA cable to the SATA
port on the HDD (left image) and then connect the power cable to the HDD (right image).
4. Place the HDDs inside the DVR, screw the HDDs from the bottom side of the DVR using the
supplied Screws.
5. Screw the housing cover back to the DVR.
3
Advertisement
Table of Contents
