PROAIM CINEMA Series Assembly Manual page 2

Blimp Assembly
•
Loosen & tighten the ratchet knob to adjust
the blimp handle as per your requirement.
Next, rotate and open the end cap.
•
Open the locking clips at both the ends of the
blimp cage and slide out the mic holder rod.
NOTE: The rubber and holder clamps come
attached to the rod. But if any rubber or
clamp is not in a good condition, you can
replace it as shown in the images.
•
Insert Mic into the suspension system and
connect it to a connector cable. Then,
re-attach the blimp cage.
•
While using the blimp extension, attach the
extension to the blimp and close the blimp
windscreen with the end cap.

To increase the height of the boom pole,
loosen and remove the ratchet knob on the
handle of the blimp cage. Then attach the
adapter set to the handle. Finally, insert the
screw inside the thread of the adapter set.
2