AIR-EAGLE
900 MHz RF Transceiver
MODEL 44-40100-DC
DESCRIPTION
The A
-E
XLT RF T
IR
AGLE
RANSCEIVER IS
transmit and receive unique signals from another transceiver located up to
2500 feet away. This model comes equipped with a single contact input
and a 5amp SPDT relay output. This allows the user to not only transmit
information out, but receive a confirming signal back that the operation
was performed. The Air-Eagle XLT TRX is user-programmable for up to
seven network frequencies to allow multiple systems to operate
simultaneously in the same area and utilizes spread-spectrum technology
and provides the utmost security and reliability even in the noisiest RF
environments. A terminal strip has been provided for interfacing with
external dry contact inputs as well as dry contact relay outputs. This unit
can operate remote machinery such as pumps, gates, chutes etc.
APPROVALS
United States (FCC)
Canada (IC)
APPLICATIONS
Doors, gates, barriers, tail gates, electrically controlled hydraulic valves,
propane shut off controls, winches, anchor lifts, lights, sprinkling systems,
movie screens, curtains, news weather screens, alarm systems, skeet
throwers, saw mill applications, grain or aggregate chutes, conveyor belts,
boat lifts, and more.
INSTALLATION
DISCONNECT DC Power from all equipment before installation.
1.
Mount the A
-E
IR
AGLE
location.
2.
Install wiring to contact input terminal strip
3.
Install antenna onto connector located on the right side on the
enclosure.
4.
Connect DC power to the proper terminals in your control
circuit.
TERMINAL STRIP WIRING
TER 3
DRY CONTACT INPUT
RELAY OUTPUT
1
Input 1 C
1
2
Input 1
2
3
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
XLT
a single I/O unit designed to
MCQ-XB900HP
1846A-XB900HP
XLT T
in a convenient
RANSCEIVER
TER 2
TER 1
AC/DC POWER INPUT
N/O
1
(-) 9-36VDC
C (common)
2
(+) 9-36VDC
N/C
3
Not Used
PRODUCT INFORMATION
BULLETIN
Dimensions (with mounting plate) 7.07L x 3.57W x 1.62H
CONTROLS AND INDICATORS
Power – LED1
Illuminates green when unit is powered
TX – LED2
Illuminates red when unit is transmitting
Relay – LED3
Illuminates green when relay is energized
RF module that sends data to the remote
RF1
receiver
Seven dip switches for selecting options and
SEL1
network frequency
TER3
Dry contact input
TER2
Relay output
TER1
Power Input