Installation Kit; Installation; Wall Mounting; Mounting In Control Cabinet - Grundfos CIU Installation And Operating Instructions Manual

3. Installation kit

The CIU package contains these parts:
• CIU unit with CIM module
• DIN rail clip with screws
• installation and operating instructions for
the CIU unit
• installation and operating instructions for
the CIM module
• Quick Guide
• CD-ROM (software, functional profiles,
installation and operating instructions).
Keep the CD-ROM and the installation
and operating instructions so that they
Note
are easy to find when the CIU unit/
CIM module is to be integrated into
the main communications network.

4. Installation

The CIU unit can be mounted on a wall or on
a DIN rail in a control cabinet.

4.1 Wall mounting

Mount the CIU unit on the wall. See fig. 2 and the
drilling template in the Quick Guide to the CIU unit.
91 mm
Fig. 2 Wall mounting of the CIU unit

4.2 Mounting in control cabinet

When the CIU unit is mounted in a control cabinet
containing a frequency converter, it is especially
important to ensure an EMC-correct installation of
both the CIU unit, CIM module and frequency
converter.
The following rules must therefore be observed:
• All cable screens must be connected to earth.
If it is not possible to use cable clamps, the
stripped part of the cable screen must be as short
as possible to reduce the impedance at high
frequencies.
• All units in the control cabinet must be connected
to earth.
Mounting on DIN rail
The CIU unit is prepared for mounting on a 35 mm
DIN rail (EN 50022).
1. Fix the DIN rail clip supplied on the CIU unit.
See the instructions on the CIU unit.
2. Fit the CIU unit by hooking the top on the DIN rail
and clicking the bottom onto the rail. See fig. 3.
Fig. 3
Dismounting from DIN rail
Remove the CIU unit by pulling it downwards and
free of the DIN rail.
Ø 4.5 mm
CIU unit on DIN rail
9