Intended Use; Technical Data; Machine Features - Festool KS 60 E Original Instructions Manual

CAUTION
Depending on how the power tool is used,
particularly which type of workpiece is being
machined, the noise emitted by the power
tool during use may deviate from the speci-
fied values.
► To protect the operator, safety measures
should be defined based on load estimates
obtained under real conditions of use. (All
parts of the operating cycle must be taken
into account here, including, for example,
times in which the power tool is switched
off or when it is switched on but idling.)
3

Intended use

The power tool is a stationary unit designed for
sawing blocks of wood, plastic, aluminium pro-
files and similar materials. Do not use it to
process other materials, in particular steel,
concrete and mineral materials.
Only use Festool saw blades that are designed
for use in this power tool.
The saw blades must comply with the following
data:
– Saw blade diameter 216 mm
Cutting width 2.3 mm (corresponds to the
–
tooth width)
– Locating bore 30 mm
– Standard blade thickness1.6 mm
Saw blade in accordance with EN 847-1
–
Saw blade with chip angle ≤ 0°
–
– Suitable for speeds above 5000 rpm
Festool saw blades comply with EN 847-1.
Only saw materials for which the saw blade in
question has been designed.
This power tool may only be used by experts or
instructed persons.
The user is liable for damage and acci-
dents caused by improper and non-inten-
ded use.
4

Technical data

Sliding compound mitre
saw
Power
Power supply
Speed (no-load)
[2] Max. speed in the event of faulty electronics.
KS 60
1200 W
220–240 V~ 50–60
Hz
1300–3500 rpm
Sliding compound mitre
saw
Max. speed
[2]
Max. mitre angle
Max. inclination angle
Saw blade dimensions
Weight as per EPTA-
Procedure 01:2014
5

Machine features

Handle
[1-1]
Safety button
[1-2]
On/Off switch
[1-3]
Lever for groove depth limit
[1-4]
Rotary knob for slide locking device
[1-5]
Lever for transport locking device
[1-6]
Spindle stop
Stop ruler (both sides)
[1-8]
Rotary knobs for securing the table
[1-9]
extension (both sides)
Angle display for mitre cuts
[1-10]
Lever for locking the mitre angle
[1-11]
Rotary base
[1-12]
Pendulum guard
[1-13]
Cable clamp
[2-1]
Extractor connector
[2-2]
On/off switch for spotlight (available
[2-3]
as an accessory depending on the
model)
FSZ120 fastening screw clamp
[2-4]
Adjusting wheel for setting the speed
[2-5]
Rotary knob for securing the rotary
[2-6]
base
Table extension (both sides)
[2-7]
Bevel holder for clamping the bevel
[2-8]
Star handle for securing the inclina-
[2-9]
tion angle
Key storage box for the Allen key
[2-10]
English
KS 60
5000 rpm
60° left/right
47/46° left/right
216 x 2.3 x 30 mm
17.8 kg
23