English Contents 1 Symbols............. 24 Removing the battery pack 2 Safety warnings.........24 3 Intended use..........27 4 Technical data........... 28 5 Parts of the device........28 6 Commissioning..........28 Inserting the battery pack 7 Battery pack..........29 8 Settings............29 9 Working with the electric power tool..31 Maximum power with two battery 10 Maintenance and care.......35 packs (36 V).
Page 3
English such as the lower guard to jam. Sparks Do not use the saw until the table is clear – from abrasive cutting will burn the lower of all tools, wood scraps, etc., except for guard, the kerf insert and other plastic the workpiece.
Page 4
– Repairs and sanding work may only be car before the saw head is completely in the ried out by Festool customer service work down position. The braking action of the shops or experts. saw may cause the saw head to be sudden...
Only use original Festool accessories and The levels determined in accordance with consumables. Only accessories tested and EN 62841 are typically: approved by Festool are safe and perfectly adapted to the machine and application. Sound pressure level = 88 dB(A) –...
– Suitable for speeds of up to 5000 rpm [2-3] FSZ120 fastening clamp Festool saw blades comply with EN 847-1. Only saw materials for which the saw blade in [2-4] Bevel holder for clamping the bevel question has been designed.
(36 V). clamping set [4D-2] to secure the machine Only the front battery pack is used. Less onto the Festool MFT 3 or MFT/Kapex (SZ- power with one battery pack (18 V). KS) multifunction table. The hexagonal...
Page 8
Brake Setting the stop rulers [8] The saw KSC 60 EB comes with an electronic brake. The saw blade is stopped electronically For mitre cuts, you must adjust the stop rul within approximately two seconds of switching ers [8A-1] so that they do not impede the func...
► Remove the screw and flange [9-7]. Selecting the saw blade ► Release the spindle stop. Festool saw blades are identified by a coloured ► Press and hold the safety button [9-4]. ring. The colour of the ring represents the ma...
Page 10
English Safe working ► Clear dust and chippings by blowing out with compressed air or using a brush. When working on the machine, observe Acoustic warning signal all of the safety warnings that are listed at the start as well as the following rules: Acoustic warning signals sound and the ma...
Page 11
English Observe the workpiece dimensions the support foot [10-4] so that it is flush with the base. Maximum workpiece dimensions without extension using accessory parts Compound mitre saws The basic function of the compound mitre saw Mitre/bevel angle, to Height x width x length is to saw using a fixed saw unit with no inclina...
Page 12
English ► Cut the workpiece; slide the saw unit ► Press the release button ; if required, through the workpiece until the limit stop. relieve the tension by slightly tilting it in the ► Once the cut is complete, guide the saw unit opposite direction.
Find the sert. nearest address at: ► Replace the table top insert [14-2] and po www.festool.co.uk/service sition marking [14-3]. Always use original Festool spare ► Reattach the screws. EKAT parts. Order no. at: www.festool.co.uk/service ► Check that the position markings on a line that, at the same time, must run at a right angle to the stop rulers.
14.2 Bluetooth ® The Bluetooth ® word mark and the logos are registered trademarks of Bluetooth SIG, Inc.; they are used by TTS Tooltechnic Systems AG & Co. KG, and therefore by Festool, under licence.