Setup Your Aws Account And Permissions - Wiznet W5100S-EVB-Pico Getting Started Manual

Aws iot core
Table of Contents

Advertisement

W5100S-EVB-Pico pin-out is directly connected to the GPIO of RP2040 as shown in the picture
above. It has the same pinout as the Raspberry Pi Pico board. However, GPIO16, GPIO17,
GPIO18, GPIO19, GPIO20, GPIO21 are connected to W5100S inside the board. These pins
enable SPI communication with W5100S to use Ethernet function. If you are using the Ethernet
function, these pins cannot be used for any other purpose.
The RP2040 GPIO used inside W5100S-EVB-Pico is as follows.
I/O
Pin name
I
GPIO16
Connected to MISO on W5100S
O
GPIO17
Connected to CSn on W5100S
O
GPIO18
Connected to SCLK on W5100S
O
GPIO19
Connected to MOSI on W5100S
O
GPIO20
Connected to RSTn on W5100S
I
GPIO21
Connected to INTn on W5100S
I
GPIO24
VBUS sense - high if VBUS is present, else low
O
GPIO25
Connected to user LED
I
GPIO29
Used in ADC mode (ADC3) to measure VSYS/3
Apart from GPIO and ground pins, there are 7 other pins on the main 40-pin interface.
Pin no.
Pin name
PIN40
VBUS
PIN39
VSYS
PIN37
3V3_EN
PIN36
3V3
PIN35
ADC_VREF
PIN33
AGND
PIN30
RUN

6 Setup your AWS account and Permissions

Refer to the instructions at Set up your AWS Account. Follow the steps outlined in these
sections to create your account and a user and get started:
• Sign up for an AWS account and
• Create a user and grant permissions.
• Open the AWS IoT console
Pay special attention to the Notes.
Micro-USB input voltage, connected to micro-USB port pin 1. Nominally
5V.
Main system input voltage, which can vary in the allowed range 4.3V to
5.5V, and is used by the on-board LDO to generate the 3.3V.
Connects to the on-board LDO enable pin. To disable the 3.3V (which also
de-powers the RP2040 and W5100S), short this pin low.
Main 3.3V supply to RP2040 and W5100S, generated by the on-board
LDO.
ADC power supply (and reference) voltage, and is generated on W5100S-
EVB-Pici by filtering the 3.3V supply.
Ground reference for GPIO26-29.
RP2040 enable pin, To reset RP2040, short this pin low.
Copyright 2021 WIZnet Co., Ltd. All rights reserved.
Description
Description

Advertisement

Table of Contents
loading

This manual is also suitable for:

W5500-evb-pico

Table of Contents