Emerson FB3000 Field Installation Manual page 7

FB000 RTU Power Supply Module and Chassis Field Installation Guide
Removing Slot Covers
10. At this point, your chassis should be empty. Use a #2 Phillips head screwdriver to unscrew
the chassis from its mounting location, which could be the DIN rail mounting plate, a
panel, or a wall. Set the old chassis aside and be sure to save the screws.
Empty Chassis – Mounting Holes
11. Use a #2 Phillips-head screwdriver and the saved screws to install the new chassis to the
same mounting location.
12. Install the CPU module by pressing it into slot 1 until it snaps into place. Slide its
personality module, with the terminal block and cable(s) connected, into the lower bay of
slot 1, then use a ¼" slotted blade screwdriver to tighten the captive fastening screw at
the top of the personality module.
D301874X012
June 2021
5