Computer Mode; Selecting Computer Mode; Selecting Computer System - Sanyo PLC - 12BL Owner's Manual

COMPUTER MODE

DIRECT OPERATION
Press the MODE button on the projector or the COMPUTER button on
the remote control unit to select Computer 1, Computer 2 Input.
The "Computer 1", or "Computer 2" display will appear on the screen
for a few seconds.
MENU OPERATION
1 Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT buttons to select
Computer and press the SELECT (REAR CLICK) button.
Another dialog box COMPUTER MODE Menu will appear.
2 Press the POINT DOWN button and a red-arrow icon will
appear. Move the arrow to the mode either Computer 1 or
Computer 2, and then press the SELECT (REAR CLICK) button.
CURRENT MODE DISPLAY
When selecting the Computer Mode, the Current Mode display
appears to show the information of the computer being selected.
AUTOMATIC MULTI-SCAN SYSTEM
This projector automatically tunes to most different types of
computers based on VGA, SVGA, XGA or SXGA (refer to
"COMPATIBLE COMPUTER SPECIFICATION" on page 37).
When selecting Computer, this projector automatically tunes to
the incoming signal and projects the proper image without any
special settings. (Setting of the Computer System may be
required when connecting some computers.)
Note : The projector may display one of the following messages.
The projector cannot discriminate or detect the input
Go to PC adj.
signal from the computer. Adjust and set the
computer system manually. (Refer to page 38.)
There is no signal input from the computer. Make
No signal
sure the connection of the computer and the
projector is set correctly.
(Refer to TROUBLESHOOTING on page 53.)
If the incoming signal is digital, the "D-VGA", "D-SVGA", "D-XGA" or
"D-SXGA" display appears.
SELECT COMPUTER SYSTEM MANUALLY
To set the Computer system manually, select the mode on the
ON-SCREEN MENU.
Press the MENU button and the ON-SCREEN MENU will
1
appear. Press the POINT LEFT/RIGHT buttons to select
SYSTEM and press the SELECT (REAR CLICK) button.
Another dialog box COMPUTER SYSTEM Menu will appear.
Press the POINT DOWN button and a red-arrow icon will
2
appear. Move the arrow to the system that you want to set, and
then press SELECT (REAR CLICK) button.
36

SELECTING COMPUTER MODE

SELECTING COMPUTER SYSTEM

COMPUTER button
MODE button
Computer 1
Computer 2
Video 1
Video 2
Providing the information of the computer detected
by the projector.
SYSTEM BOX
Display the SYSTEM being selected.
The system being selected.
The systems on this dialog
box can be selected.
When this mark is
displayed as black, more
computer system modes
will be available. Move
the arrow to this mark and
then press the SELECT
(REAR CLICK) button,
and the other modes will
be displayed.
Computer 1
Computer 2
Close the
SYSTEM Menu.