Video Mode; Selecting Video Mode; Selecting Video Source - Sanyo PLC - 12BL Owner's Manual

VIDEO MODE

DIRECT OPERATION
Press the MODE button on the projector or the VIDEO button on the
remote control unit to select Video 1, Video 2 Input.
The "Video 1", or "Video 2" display will appear on the screen for a few
seconds.
MENU OPERATION
1 Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT buttons to select
Computer and press the SELECT (REAR CLICK) button.
Another dialog box VIDEO MODE Menu will appear.
2 Press the POINT DOWN button and a red-arrow icon will
appear. Move the arrow to the mode either Video 1 or Video 2,
and then press the SELECT (REAR CLICK) button.
This projector automatically detects the signal from the VIDEO
INPUT JACK(s) or the S-VIDEO INPUT JACK. When those
jacks are connected at the same time, select the type of Video
source in VIDEO SOURCE Menu.
1 Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT buttons to select VIDEO
SOURCE and press the SELECT (REAR CLICK) button.
Another dialog box VIDEO SOURCE Menu will appear.
2 Press the POINT DOWN button and a red-arrow icon will
appear. Move the arrow to the source that you want to select,
and then press the SELECT (REAR CLICK) button.
When connect the composite video output from the video
Video
equipment to the VIDEO/Y jack, select "Video" in VIDEO
SOURCE Menu.
When connect the separate Y/C video output from the
Y, C
video equipment to the VIDEO/Y and C jacks, select
"Y,C" in VIDEO SOURCE Menu.
When connect the component video output from the
Y, Cb, Cr
video equipment to the VIDEO/Y, C/Cb (B-Y) and Cr (R-
Y) jacks, select "Y, Cb, Cr" in VIDEO SOURCE Menu.
44

SELECTING VIDEO MODE

SELECTING VIDEO SOURCE

MODE button VIDEO button
Video 1
Computer 1
Computer 2
Video 2
Video 1
Video 2
This box indicates the
Video source being
selected.