Computer Mode; Selecting Computer Mode; Selecting Computer System - Sanyo LV-7300 Owner's Manual

COMPUTER MODE

Press the MODE button on the Top Control or the Remote Control Unit.
The input source is selected among COMPUTER or VIDEO. The
"Computer" or "Video" display will appear on the screen for a few
seconds.
Press the MENU button and the ON-SCREEN MENU will appear.
Press the POINT LEFT/RIGHT buttons to select Computer
press the SELECT button.
CURRENT MODE DISPLAY
When selecting the Computer Mode, the Current Mode display appears.
It shows the information of the computer of the mode selected.
Automatic Multiscanning system
This projector automatically adapt to most different types of computer
based on VGA, SVGA or XGA (refer to "COMPATIBLE COMPUTER
SPECIFICATION" on page 26). When selecting Computer, this
projector become automatically suited to the incoming signal and
projectors the proper image without any special setting. (Setting of the
Computer System may be required when connecting some computers.)
Note : The projector may provides the messages below.
The projector cannot discriminate or detect the input
Go PC adj.
signal from the computer. Adjust and set the computer
system manually. (Refer to page 25.)
There is no signal input from the computer. Make sure
No signal
the connection of the computer and the projector is set
correctly. (Refer to TROUBLESHOOTING on page 36.)
Selecting Computer System Manually
To set the Computer system manually, select the mode on the ON-
SCREEN MENU.
1 Press the MENU button and the ON-SCREEN MENU will appear.
Press the POINT LEFT/RIGHT buttons to select SYSTEM and
press the SELECT button. Another dialog box COMPUTER
MODE Menu will appear. (The COMPUTER MODE Menu also
appears by pressing the SYSTEM button on the Top Control or
the Remote Control Unit.)
Press the POINT DOWN button and a red-arrow icon will appear.
2
Move the arrow to the system that you want to set, and then press
SELECT button.
24

SELECTING COMPUTER MODE

Direct Operation
Menu Operation

SELECTING COMPUTER SYSTEM

Computer
and
The system being selected.
The systems on this
dialog box can be
selected.
When this mark
displayed as black, more
computer system modes
will be available. Move
the arrow to this mark and
then press the SELECT
button, and another mode
will be displayed.
Video
Providing the information of
the computer detected by
the projector.
SYSTEM BOX
It displays the SYSTEM
being selected.
is
It closes the
SYSTEM Menu.