Setting; Setting Menu - Sanyo PLC - 12BL Owner's Manual

SETTING

1 Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT buttons to select
SETTING and press the SELECT (REAR CLICK) button.
Another dialog box SETTING Menu will appear.
2 Press the POINT DOWN button and a red-arrow icon will
appear. Move the arrow to the item that you want to set, and
then press the SELECT (REAR CLICK) button to set it "On" or
"Off" or press the POINT LEFT/RIGHT button to adjust the
value.
Blue back
When this function is "On," this projector will produce a blue image
instead of the video noise on the screen when the input source is
unplugged or turned off.
Display
This function decides whether to display the On-Screen Displays.
On ··· shows all the On-Screen Displays.
Off ···· sets the On-Screen Displays disappeared except;
ON SCREEN MENU
"Power off?" message
P-TIMER
Reverse T/B
When this function is "On," the top / bottom reversed picture is
provided to project the image from a ceiling mounted projector.
Reverse L/R
When this function is "On," the left / right reversed picture is provided
to project the image to a rear projection screen.
Split wipe
Turn this function "On" in the SETTING menu. The picture will
change into next one by sliding black image side ways like drawing
the black curtains when the input source is turned into another one.
Power management
This function turns the Projection Lamp off when the projector
detects signal interruption and the projector is not used for a certain
period in order to reduce power consumption and maintain the Lamp-
life. (This projector is shipped with this function ON.)
Power Management function operates to turn the Projection Lamp off
when the input signal is interrupted and the projector is not operated
over 5 minutes. This function operates as follows;
1. When the signal is interrupted, "No signal" and the counting
down (5 minutes) display appears.
2. When the Projection Lamp turned off, the READY indicator
turns off. The Cooling Fans operate for 90 seconds after the
Projection Lamp is turned off. (During this "Cooling Down"
period, the Lamp cannot be turned on.)
3. When the Lamp has cooled down, the READY indicator flashes
and the Lamp can be turned on again (Power Management
mode).
In this Power Management mode, the Projection Lamp is
automatically turned on when the input signal connected or the
projector is operated with any button on the Top Control or on
the Remote Control.
48

SETTING MENU

Set the Pointer to the item
and press the SELECT
(REAR CLICK) button.
Reverse T/B function
Reverse L/R function
Time left until Lamp off.