Power Wiring - Allen-Bradley PowerFlex 40P Quick Start Manual

Aotewell Ltd
Category
Control Outputs Relay:

Power Wiring

Power Wire Rating
Unshielded 600V, 75°C (167°F) THHN/THWN
Shielded 600V, 75°C or 90°C (167°F or 194°F) RHH/
RHW-2
Shielded Tray rated 600V, 75°C or 90°C (167°F or
194°F) RHH/RHW-2
Power Terminal Block
B Frame
Terminal
R/L1, S/L2
R/L1, S/L2, T/L3 3-Phase Input
U/T1
V/T2
W/T3
P2, P1
DC+, DC-
BR+, BR-
(1)
(2)
HongKong|UK|China
All manuals and user guides at all-guides.com
www.aotewell.com
Specification
Quantity:
Specification
Resistive Rating:
Inductive Rating:
Opto: Quantity:
Specification:
Analog: Quantity:
Specification
Resolution:
0 to 10V DC Analog:
4-20mA Analog:
R/L1 S/L2 T/L3 U/T1 V/T2 W/T3
DC- DC+ BR+ BR-
(1)
Description
1-Phase Input
To Motor U/T1
To Motor V/T2
To Motor W/T3
DC Bus Inductor Connection (C Frame drives only.)
The C Frame drive is shipped with a jumper between
Terminals P2 and P1. Remove this jumper only when a DC
Bus Inductor will be connected. Drive will not power up
without a jumper or inductor connected.
DC Bus Connection
Dynamic Brake Resistor Connection
Safety Ground - PE
Important: Terminal screws may become loose during shipment. Ensure that all
terminal screws are tightened to the recommended torque before applying power to
the drive.
Single-phase operation requires a 65% derate of drive rated current.
sales@aotewell.com
(1) Programmable Form C
3.0A at 30V DC, 3.0A at 125V, 3.0A at 240V AC
0.5A at 30V DC, 0.5A at 125V, 0.5A at 240V AC
(2) Programmable
30V DC, 50mA Non-inductive
(1) Non-Isolated 0-10V or 4-20mA
10-bit
1k ohm minimum
525 ohm maximum
Recommended Copper Wire
15 Mils insulated, dry location
Anixter OLF-7xxxxx,
Belden 29501-29507 or
equivalent
Anixter 7V-7xxxx-3G
Shawflex 2ACD/3ACD or
equivalent
C Frame
R/L1 S/L2 T/L3 U/T1
DC- DC+
(2)
=
Industry Automation
English-7
V/T2 W/T3 P2 P1
BR+ BR-
Switch any two motor
leads to change
forward direction.
+86-755-8660-6182