Transport, Storage And Operating Conditions - REA VeriCube Operating Manual

3

Transport, storage and operating conditions

The REA VeriCube can only be transported in the supplied
ATTENTION
case or transport packaging.
N
Transport: The REA VeriCube is delivered in a case or in a cardboard
box with adequate foam padding. This package should be preserved
for possible transportation. The REA VeriCube should only be
transported in its original packaging, especially with parcel services
and similar means. In case, it is shipped without the original
packaging though, it should be packaged with good padding, so that
the device cannot move in the cardboard shipment box.
The glass pane must always be removed for transport and the plastic
pane must then be used as a protection. The glass cover must always be removed
prior to the transportation and then the plastic cover must be used as protection.
After transportation, the device must be warmed up to room temperature because
the optical parts can be fogged by the temperature change.
Storage: The device should always be stored in dry, dust-free rooms and at room
temperature. When not in use, the device should be covered or stored in the
transport packaging to protect it from dust deposits. For storage, remove the glass
pane and insert the plastic pane.
Dust on the optically effective surfaces leads to misalignment of the optical
measuring paths. This leads to incorrect measurement results.
Operation: Humidity, cold, heat and mechanical impacts incurred when the
equipment is dropped, can lead to a situation where the measuring chamber cover as
well as the mechanical and electronic parts can be damaged or destroyed.
If the device still provides measurement results with these damages, there is a high
risk that these results are incorrect or deviate too far from the correct values.
The device is delivered with a plastic cover and a top plate, which protect the
measuring chamber. The plastic cover serves as dust protection during the storage
and transportation of the REA VeriCube. The glass plate serves as a top plate in the
event that the codes to be measured need to be placed on the surface. The glass top
plate must always be removed prior to the transportation and the plastic cover used
as protection.
© REA Elektronik GmbH, Teichwiesenstraße 1 D-64367 Muehltal
REA VeriCube Operating Manual Version 2.16 – 11/2020 Page 12 of 119