Safety Instructions; General Safety - REA VeriCube Operating Manual

4

Safety Instructions

4.1

General safety

Before setting up the REA product and using it, please read and strictly observe
these operating instructions very carefully, especially the safety instructions.
Supplementary notes can be found in Annex 24. Symbols are described in 24.1.
The REA Verifier tester REA VeriCube is built according to state of the art and
recognized safety regulations. Nevertheless, its use risks to life and limb of the user
or others, or damage to the REA VeriCube or other property may arise.
The REA VeriCube is
 to use in accordance with the intended use.
 to put into operation in absolutely perfect condition.
Disorders that may affect safety must be rectified immediately.
(See chapter "Intended Use, Chapter 24.6").
In case of breakdown, the REA VeriCube must shut down immediately and must only
be taken back into operation after proper repair!
Warning:
Commissioning, operation and any subsequent applicable
service may only be performed by trained personnel.
Warning:
Before maintenance work or other interventions, it is
obligatory to turn off the verifier and unplug the power
cord. Otherwise there is a risk of damage on the device or
even personal injury because of electrical voltage.
Warning:
Don't cover the power supply (PoE injector). Risk of
overheating and danger of fire.
Warning LED lighting:
In the REA VeriCube, LEDs with red light 660nm and white
light 4000K are used. It is essential to avoid looking directly
into the LEDs, otherwise the eyes might be damaged.
© REA Elektronik GmbH, Teichwiesenstraße 1 D-64367 Muehltal
REA VeriCube Operating Manual Version 2.16 – 11/2020 Page 13 of 119