Valor H5 Series Installation Manual page 4

3. On the appliance, install the side panels as indicated
(3 x 1/2" screws per side).
4. Install the upper fi nishing strip in the orientation
shown below, under the appliance's case top edge.
The fi nishing strip is secured to the appliance using
the removable baffl e's 3 existing screw holes.
Curves upwards
in fireplace
Front
Bottom
Side View
With no HeatShift. Remove the 3 screws retaining
the removable convection baffl e and discard them.
Slide the fi nishing strip over the baffl e's tabs, then
secure the strip and baffl e together to the appliance
using 3 countersunk screws supplied with this kit.
Convection baffle
Finishing strip installed
4
Rear
Finishing strip
ONLY with HeatShift. Remove the 3 screws retain-
ing the removable convection baffl e. Remove the
baffl e, then slide the fi nishing strip over the screw
holes and secure it with 3 countersunk screws
supplied. Discard the convection baffl e and its
original screws.
NOTE
Use of the optional HeatShift System requires
the convection baffle to be removed above the
firebox. See Appliance Preparation, Optional
HeatShift or HeatShift section in Appendix D of
the appliance's installation manual.
Convection baffle
removed
Finishing strip installed
Ensure there is no gap between the upper fi nishing
strip and the side panels.
If there is a gap, loosen the side panel's 3 screws,
push the panel up to close the gap and tighten the
screws.
Upper
finishing strip
Side
panel
Finishing strip