Download Print this page

Din Rear-Mount (Method B) - Sanyo ECD-T1137S Owner's Manual

Pll synthesized stereo radio with digital compact disc player
Hide thumbs

Advertisement

1
6
4
5
2
3
(Fig. 2)
Removing the unit
1
2
3

DIN REAR-MOUNT (Method B)

Installation using the screw holes on the sides of the unit.
1
3
2
5
1. Dashboard
2. Nut (5mm)
3. Spring washer
4. Screw (5 x 14mm)
5. Screw
6. Strap
Be sure to use the strap to secure the
back of the unit in place. The strap can
be bent by hand to the desired angle.
1. Frame
2. Insert fingers into the groove in the front
of frame and pull out to remove the
frame. (When reattaching the frame,
point the side with a groove downwards
and attach it.)
3. Lever
Insert the levers supplied with the unit
into the grooves at both sides of the unit
as shown in figure until they click.
Pulling the levers makes it possible to
remove the unit from the dashboard.
Fastening the unit to the factory radio
mounting bracket.
1. Select a position where the screw holes
of the bracket and the screw holes of
the main unit become aligned (are fitted),
2
and tighten the screws at 2 places on
each side.
4
Use either truss screws (5 x 5mm) or
flush surface screws (4 x 5mm),
5
depending on the shape of the screw
holes in the bracket.
2. Screw
3. Factory radio mounting bracket
4. Dashboard or Console
5. Hook (Remove this part)
Note: The mounting box, outer trim ring,
and half-sleeve are not used for method B
installation.
3

Advertisement

loading

  Related Manuals for Sanyo ECD-T1137S