Advertisement
Available languages
Available languages
10
• To drain water from the bottom drainage port when the display shows
H8.
Drainage method
1 Drain water from the bottom drainage port.
• Turn off the unit and pull out the plug from the socket.
• Place a water container under the bottom drainage port, or move the
machine to a place where it can drain.
• Remove the rubber plug of the bottom drainage port to drain water.
• After draining, insert the rubber plug.
• Press ON/OFF button to restart.
2 Drain water from the middle drainage port.
NOTE
ū Water can be autamatically emptied into a floor drain by attaching
13 mm inner diameter hose (not included).
1. Remove the continuous drain cap by turning it counter clockwise then
remove the rubber stopper from the spout.
2. Insert a 13 mm inner diameter hose (not included) onto drain
connector.
ATTENTION:
ū When using continuous drainage option from the middle hole, place
the unit on a level surface and make sure drainage hose is clear of any
obstructions and is directed downward. Placing the unit on an uneven
surface or improper hose installation may result in water filling up the
chassis and causing the unit to shut off. Empty water in the chassis if
shut off occurs, then check the unit location and hose for proper setup.
Installing Heat Discharge Pipe
Install heat discharge pipe
1. Rotate joint A and Rear clip clockwise into the two ends of heat
discharge pipe.
2. Insert joint A of heat discharge pipe into the groove until you hear a
clicking sound.
clasp
groove
3. Lead the heat discharge pipe outdoors.
Note on installing heat discharge pipe
In order to improve cooling efficiency, the heat discharge pipe should be as
short as possible and flat without curve to ensure smooth heat discharge.
The discharge pipe is suggested to be installed according to below figure .
Discharge pipe can be installed based on user's requirement, while
installation form as shown below should be avoided as it may lead to
non-uniform exhaust.
• If the length of the heat discharge pipe is less than 1 meter. It is
recommended to use it with shortest length.
• When installing, heat discharge pipe should be as flat as possible. Do not
lengthen the pipe or connect it with an other heat discharge pipe.
Advertisement
