General Pipe Cleaners Cold-Shot Operating Instructions Manual

General Pipe Cleaners Cold-Shot Operating Instructions Manual

For 1/8” through 2” metal and plastic lines (10mm—60mm)

Advertisement

M
Your Cold-Shot is designed to give you
years of trouble-free, profitable service.
However, no machine is better than its op-
erator.
Read, understand and follow all safety
warnings and instructions provided with
the product. Failure to follow the warnings
and instructions may result in electric
shock and/or serious injury. Save all warn-
ings and instructions for future reference.
SAVE THESE INSTRUCTIONS!
Cold-Shot
Operating Instructions
For 1/8" through 2" metal and plastic lines
(10mm—60mm)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Cold-Shot and is the answer not in the manual?

Questions and answers

Summary of Contents for General Pipe Cleaners Cold-Shot

  • Page 1 ™ Cold-Shot Operating Instructions For 1/8” through 2” metal and plastic lines (10mm—60mm) Your Cold-Shot is designed to give you years of trouble-free, profitable service. However, no machine is better than its op- erator. Read, understand and follow all safety warnings and instructions provided with the product.
  • Page 2: General Safety Rules

    Carbon dioxide is heavier than air operation and maintenance and can collect at ground level and displace the air if ventilation procedures for the Cold-Shot. is inadequate. This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
  • Page 3: Specific Safety Rules

    Personal Safety tool. 1. Work only in a well ventilated area. Carbon diox- 11. Only use the Cold-Shot for the purpose for which ide is non-toxic and non-flammable, but is heavier it was intended. Any unauthorized use or modifica- than air and can collect at ground level, displacing...
  • Page 4: Operation

    HOW THE COLD-SHOT WORKS FRACTURES AND CAUSE THE FREEZE HEADS TO SHATTER. The Cold-Shot can be used to freeze all types of liquids, even at high pressure, inside steel, copper, cast iron, 6. Push each injector into the bore of the freeze head lead, aluminum and plastic pipe in sizes ranging from 1/8”...
  • Page 5 Cold-Shot™ 3. After a brief period, frost will form on the pipe in the 5. While work is in progress, the flow of carbon di- vicinity of the freeze heads. (See Table) If frost does oxide refrigerant must be maintained. To ensure a...
  • Page 6: Troubleshooting Guide

    Cold-Shot™ TROUBLE SHOOTING GUIDE Problem Cause Solution Liquid won’t freeze Liquid still flowing. All liquid flow must be stopped. Pipe not full. Pipe must be full of liquid to create a solid plug when frozen. Incorrect CO tank Must use CO tank with dip tube.

Table of Contents