Update The Software - Hach DR300 Service Manual

4.7 Update the software

Figure 9 Update the software
Note: Following hyperlink without being logged will end in a permission denied information
screen.
1. Install the service cable VAA10036.99.G00 in the DR300. Refer to
cable on page 19.
2. Start the VAP235 software.
3. Connect the service cable VAA10036.99.G00 to an USB port.
4. Push on the DR300.
5. Push Connect. The display of the DR300 shows serial.
6. Push Update. Refer to
7. If no update is necessary the information "Instrument is up to date" is shown.
Note: If VAP235 is configured to perform the update automatically (Enable updates, refer to
Figure 7 on page 18) an manually update of the software is not necessary.
Figure 9.
Inspection
Insert the service
33