Moving To Another Location In The Same Building - Epson SC-P8500D Series User Manual

SC-P8500D Series/SC-T7700D Series
Caution:
❏ The printer is heavy and should not be carried
by one person. When you pack or move the
printer, use four or more people when
carrying it.
❏ When you lift the printer, maintain a natural
posture.
❏ When you lift the printer, place your hands at
the locations indicated in the following
illustration.
If you lift the printer while holding other
sections, you may be injured. For example,
you may drop the printer or your fingers may
be pinched when lowering the printer.
❏ Do not tilt the product more than 10 degrees
forward or back while moving it. Failure to
observe this precaution could cause the
product to tip over or ink to leak.
User's Guide
Appendix
c
The print head may be damaged if the
environmental temperature falls to -10 °C or lower.
If the environmental temperature is expected to be
-10 °C or lower during movement or
transportation, drain the ink before turning off
the power.
See the following for more detailed instructions.
U
Transportation Drops to -10 °C or Lower" on
page 198
Moving to Another Location in
the Same Building
Preparations before moving
This section describes how to move or transport the
printer.
It explains how to prepare for a short move, such as to
another location in the same building. See the
following if you are moving the printer between floors
or to another building.
"Transporting the Printer" on page 198
U
If there are no steps or uneven surfaces in the moving
path, you can roll the printer on its casters, but note
the following points.
To prevent accidents such as falling, note the
following points when moving the printer.
❏ Do not move while the casters are locked.
❏ Avoid steps and uneven surfaces.
A
B
C
197
Important:
"If the Environment Indoors or During
Caution:
Remove all paper from the printer.
Turn off the printer, and disconnect all cables
such as the power cable and LAN cable from
the printer.
Close all of the printer's covers.