Initial Switch Configuration Via Cli; Switch Cli Command Notes - Lantronix SM24TBT2DPB Install Manual

Lantronix

Initial Switch Configuration via CLI

Use an RJ-45 cable to connect a terminal or PC/terminal emulator to the switch port to access the CLI.
Attach the RJ-45 serial port on the switch front panel to the cable for Telnet/CLI configuration.
Attach the other end of the DB-9 cable to a PC running Telnet or a terminal emulation program such as
HyperTerminal or Tera Term.
After powering up the switch for the first time, you can perform the initial switch configuration using the CLI
(Command Line Interface). For managing other switch features, see the CLI Reference for details.

Switch CLI Command Notes

The SM24TBT2DPB show system command:
The SM24TBT2DPB show power management command with one PS-ACDC-1200 power supply installed:
SM24TBT2DPB# show power management
Power Management
=========================
Power
Detected PSU
Power Good
Power Input(AC/DC)
Power Input Voltage (V) : 123
FAN Speed (RPM)
Temperature (Degree C)
Operating Mode
SM24TBT2DPB#
Note: the PS-ACDC-1200 power supply is displayed as Detected PSU = "PSU-HV".
33845 Rev. B
: A B
: PSU-HV None
: Good Fail
: Good Fail
---
: 2911 0
: 42 0
: Redundant
https://www.lantronix.com
SM24TBT2DPB Install Guide
Page 30 of 48