Table of Contents
Advertisement
Before washing for the first time
Top up rinse aid
Add rinse aid to the container for rinse aid (if the dishwasher has not been connected to a system
for the automated dosage of rinse aid).
1. Open the rinse aid compartment lid.
2. Carefully top up with rinse aid to the level marked max.
3. Wipe up any splashes of rinse aid around the compartment.
4. Close the lid firmly.
4.
Water hardness 0/1/2/3/4/5/6/7/8/9
Adjusting the water softener. Select a setting depending on the hardness of the water supply. It is
important that this setting is correct!
Do not forget to put salt in the salt compartment after you have set the water softener to 1 - 9.
For a water supply with a hardness under 4°dH (6°fH), select 0. The water softener is deactivated
and no salt is needed.
Pre-selected at factory: 6
Top up salt
1. Unscrew the salt compartment lid.
2. Place the funnel supplied with the dishwasher in the salt compartment top-up hole. First, pour
in about 1 l of water.
3. Then add salt, a maximum of 630 gram, until the compartment is full. Use large grain salt or
special dishwasher salt.
4. Wipe up any excess salt so that the lid can be screwed on firmly.
8
Press to open
Salt compartment lid
Advertisement
Table of Contents
