Installation
5. Check that there is an air gap of at least 3 mm between the underside of the worktop and the
top edge of the dishwasher.
6. Slide the dishwasher into place.
•
Pull in the inlet and outlet hoses and the power cable when the dishwasher is slid into place.
If automated dosage has been installed, carefully pull in the hoses and external cables for
that as well.
•
Check that the hoses have no kinks or sharp bends, and check that there is nothing that
can damage the hoses.
7. Make any final adjustments to the feet (the dishwasher may lean no more than 5 mm) and tighten
the lock nuts on the front feet.
Drainage connection
This dishwasher is suitable for installing in a raised recess (to attain an ergonomic working height).
This means that the dishwasher can be placed so that the drainage hose runs to a lower level than
the bottom of the dishwasher, such as by routing it directly to a floor drain. The dishwasher is fitted
with an integrated anti-siphon device to prevent the machine from being emptied of water during
the wash cycle.
44
16 mm
24 mm