Table of Contents
Advertisement
Table continued from last page
Problem
"Salt chamber is empty, top up
before running program" is
shown on the display.
Water remains in the
dishwasher.
Bad odour in dishwasher.
Grease deposits in the
dishwasher.
Possible causes
Salt compartment empty.
The filters are blocked.
The filters are not fitted correctly.
Debris in the drainage pump.
Drainage pump stop missing.
Kink in drainage hose.
Blocked drainage hose.
Dirt around the seals and in
corners.
Low temperature programs have
been selected for a prolonged
period.
Low temperature programs have
been selected for a prolonged
period.
Troubleshooting
Action
Top up with salt. See the
chapter Care and cleaning.
(The setting to prevent a
dishwashing program from
starting when the salt
compartment is empty can be
deactivated. See the Settings
chapter.)
Clean the coarse and fine filters.
Check that the filter handle is
locked in the stop position.
Clean the drainage pump. See
the chapter Care and cleaning.
Check that the coloured stop on
the right in the bottom drain is in
place. See the chapter Care and
cleaning.
Check that the hose is free from
kinks and sharp bends.
Disconnect the drainage hose
where it connects to the sink
unit's water trap. Check that no
debris has fastened and that the
connection has an inner
diameter of at least 14 mm.
Clean with washing-up brush
and low foaming cleaner.
Run a program with a high
temperature once or twice a
month. Or run a self-cleaning
program. See Self-cleaning in
the chapter Using the
dishwasher.
Or run a self-cleaning program
once or twice a month. See
Self-cleaning in the chapter
Using the dishwasher.
Select a program with a high
temperature to dissolve grease
on very dirty dishes, such as
Intensive. Or run a self-cleaning
program once or twice a month.
See Self-cleaning in the chapter
Using the dishwasher.
37
Advertisement
Table of Contents
