Raider RD-PCM29 User Manual page 25

25
10. Plasma burner maintenance:
The consumables shown on page 3 can be replaced by unscrewing the nozzle clamping sleeve.
The electrode is to be replaced when a recess of approx. 1.5 mm appears in the middle.
ATTENTION! To unscrew the electrode, do not apply thrust, but gradually until the thread is
released. The new electrode must be placed and fixed in place, but not fully tightened. The nozzle
is replaceable when the middle hole is damaged or has widened compared to the hole in a new
nozzle. If the electrode or nozzle is not replaced in time, this leads to overheating of the parts. This
reduces the operational
diffuser life. After replacement, make sure that the nozzle clamping sleeve is tight.
ATTENTION! The nozzle clamping sleeve can only be screwed onto the torch after the electrode,
diffuser and nozzle have been fitted.
INSTRUCTION! The plasma cutting machine must be regularly serviced for trouble-free operation
and compliance with safety requirements.
Improper and incorrect operation can cause malfunctions and damage to the appliance. Switch off
the main power supply and the main switch of the appliance before carrying out maintenance or
repairs on the plasma cutting machine.
Regularly clean the outside of the plasma cutter. Remove dirt and dust with air, cleaning wire or a
brush.
• Storage
When the appliance is not in use, store it in a dust-free, clean and dry place.
• Warranty and service instructions
The product is intended for private use only and not for commercial use. In case of abuse and
improper treatment, use of force and interventions that have not been performed by the branch of
our authorized RAIDER service, the warranty is void.
11. Environmental protection.
In order to protect the environment, the power tool and its packaging must be properly recycled for
the reuse of their raw materials. Do not dispose of power tools with household waste! According to
the Directive of the European Union 2012/19 / EC on end-of-life electrical and electronic devices
and the approval and as a national law, power tools that can no longer be used must be collected
separately and subjected to appropriate processing to utilize the are in them raw materials.