Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for IFM SL010 Series
Summary of Contents for IFM SL010 Series
- Page 1 Operating instructions Airflow monitor SL010x SL030x...
-
Page 2: Table Of Contents
SL010x SL030x Airflow monitor Contents Preliminary note ............. Symbols used . -
Page 3: Preliminary Note
Airflow monitor SL010x SL030x 1 Preliminary note You will find instructions, technical data, approvals and further information using the QR code on the unit / packaging or at www.ifm.com. 1.1 Symbols used Requirement Instructions Reaction, result [...] Designation of keys, buttons or indications... -
Page 4: Safety Instructions
SL010x SL030x Airflow monitor 2 Safety instructions • The unit described is a subcomponent for integration into a system. – The system architect is responsible for the safety of the system. – The system architect undertakes to perform a risk assessment and to create documentation in accordance with legal and normative requirements to be provided to the operator and user of the system. -
Page 5: Intended Use
Airflow monitor SL010x SL030x 3 Intended use The unit monitors airflows and switches a relay. -
Page 6: Function
• Normally open: relay energises. green • Normally closed: relay de-energises. below the set value • Normally open: relay de-energises. • Normally closed: relay energises. *Information on the unit type (NO or NC) Ò Technical data at http://documentation.ifm.com. -
Page 7: Installation
Airflow monitor SL010x SL030x 5 Installation u Drill a hole with a diameter of 24 mm in the pipe. u Mount the unit using the supplied mounting clamp: • Use the supplied seal for a hermetically sealed installation. • The sensor head must protrude completely into the airflow and should be in the area of the highest flow velocity. -
Page 8: Electrical Connection
SL010x SL030x Airflow monitor 6 Electrical connection The unit must be connected by a qualified electrician. u Observe the national and international regulations for the installation of electrical equipment. The design of the unit complies with protection class II. The unit complies with overvoltage category II. The permissible potential difference between supply and output circuit is max. -
Page 9: Settings
Airflow monitor SL010x SL030x 7 Settings LEDs setting potentiometer sensitivity Fig. 5: Operating and display elements Flow adjustment for setting the switching point: u Switch on the power supply. u Let the normal flow circulate in the installation and keep it constant. w Both LEDs (red and green) are on. -
Page 10: Operation
SL010x SL030x Airflow monitor 8 Operation After switching on the supply voltage, both LEDs come on for approx. 60 s, the output relay is energised (power-on delay time). Then the unit is ready for operation.
Need help?
Do you have a question about the SL010 Series and is the answer not in the manual?
Questions and answers