Advertisement
Introduction
Thank you for choosing to purchase this quality product. To minimise the risk of injury, we ask you to
always take some basic safety precautions when using this product. Please read this operating manual
carefully and make sure that you understand it.
Keep these operation instructions in a safe place.
Safety instructions
•
Before commissioning the device, fix all covers and safety equipment.
•
Before commissioning the device, check it for damages.
•
Before commissioning the device, make sure that the indications on the nameplate match the
specifications of the local mains.
•
Before using the device, check the power cord and plug for damage.
•
Only use the device with the grinding disc suitable for the individual task.
•
When using the device, respect all safety instructions. For your proper safety and for the safety
of others, respect these instructions before using the device.
•
Never remove deliberately any mounted protective equipment.
•
This circular saw blade sharpener is only suitable to sharpen saw blades of the admissible di-
mensions.
•
Never use the device during rain and in damp or wet zones. Refer to the technical specifications.
•
Do not remove any protective equipment and do not touch any moving or hot piece.
•
Keep children away from the device.
•
Only operate the device within the rated power range. Do not overcharge the device.
•
Recycle the packaging material.
•
Any structural or other modification of the device leads to the manufacturer's responsibility ex-
piring.
•
Do not use the device when being tired or under the influence of alcohol, drugs, or medicine.
•
Abide by the applicable occupational health and safety regulations and accident prevention reg-
ulations.
•
After switching off, wait for the engine to come to a standstill.
•
Before use, make sure that the protective equipment works properly.
•
You should replace defective protective equipment immediately.
•
Before use, check that all tools and wrenches have been removed.
•
Keep this manual for future reference.
•
When leaving your workplace, always switch the device off and pull the plug out.
•
In case of an emergency, immediately switch off the device and pull out the plug.
•
Attention!
This sharpener may only be used according to its intended purpose and must be
equipped with a grinding disc suiting the material to be sharpened.
•
Before any maintenance or cleaning job, pull out the plug.
•
When transporting the device, apply the transport equipment.
•
Only use authorised extension cords. The length of a cable of a cross section of 1.5 mm² /
2.5 mm² must not exceed 50 m / 100 m.
•
Do not use the device in case the power cord is damaged. Never use the power cord to carry
the device or to plug the plug out.
•
The sharpener must be supplied and protected via a residual current circuit breaker with a trip-
ping residual current of no more than 30 mA.
•
Protect the power cord from sharp edges and caustic liquids.
•
Always wear a dust mask.
•
Do not use the device near flammable liquids or gases.
•
Wear appropriate workwear. When you work outdoors, it is advisable that you wear work gloves,
non-skid shoes, tight-fitting clothes, and protective glasses.
•
During operation, never reach your hands or other objects into the working range of the device.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Fire and explosion hazard!
Item 30167
Page 3
01
2022-1
Advertisement
