ADC Diagnostix ADSTATION Assembly Instructions

93-5630-00 rev 2.qxp_Layout 1 3/17/22 9:32 AM Page 1
Diagnostix
ADST A TION
1. Position the specula drilling template on the wall
where desired and tape into place.
2. With a pencil, mark two holes on the wall where
indicated, then remove template from the wall.
3. Using a 7/32" bit, drill holes where marked, about 1
1/4" deep. Push the supplied screw anchors into the
holes until flush against the wall.
4. Take the dispenser portion of the unit (Figure 1) and
check to ensure the spacer caps are in place on the
back. Push the two supplied screws into the holes
on the front of the unit and position it in on the wall
in line with the anchors. Screw snugly into place.
5. Next attach the faceplate (Figure 2). To do so, align
the four grooved tracks on the sides of the faceplate
with the corresponding guides on the dispenser.
Push firmly until the faceplate clicks into place.
6. To attach the lid (Figure 3), align the lid tabs with the
corresponding holes on the faceplate until the lid
rests in position.
7. Fill the dispenser as needed.
TM
Modular Diagnostic System

Specula Extension Assembly Instructions

See illustrations on reverse side.
TM