fantastic furniture Java Manual page 8

Step 5
You will need
18 x Screws
6 x Slides
12mm (H18)
(H19)
Phillips Head 8 x Dowels
Screwdriver ø8mm (H3)
Mallet
H3
H18
H3
H19-1
H19-1
Attach 6 x separated slide tracks (H19-1)
onto left & right side panels (P2, P4)
with 18 x screws (H18), using a phillips head screwdriver as shown.
Ensure the slide tracks (H19-1) are attached so the rubber stopper is positioned
near the grooves on left & right side panels (P2, P4) as shown.
Insert 8 x dowels (H3) into left & right side panels (P2, P4) as shown.
If needed use a mallet to gently tap the dowels into place.
fantasticfurniture.com.au
Separate the 12 x slide runners (H19-2) and slide tracks (H19-1)
from the slides (H19) by following the steps below:
Extend the slide runner (H19-2) all the way out.
Press down the plastic release lever on the slide track (H19-1)
and pull out the slide runner (H19-2) completely.
H19
Slide runner H19-2
H18
H18
H18
H18
H18
(P2)
H19-1
Adjust runner to access the screw holes.
Please fasten the screws through
these holes for this step.
Note the position of the rubber stopper
H19-1
H3
H3
H18
(P4)
H3
H3
Slide track H19-1
H19-1
H18
H18
H18
H18
H19-1
H19-1
H19
H19-1
H19-1
H3
H18
H3
H19-1
Page 8