Download Print this page
HealTech Electronics GIpro DS Series Installation And Operation Manual

HealTech Electronics GIpro DS Series Installation And Operation Manual

Advertisement

Quick Links

For use with the following TRIUMPH motorcycles:
Daytona 650
(2005),
Sprint ST 1050
(2005-2010),
Foreword
Congratulations on your purchase of a GIpro-DS gear position indicator.
The GIpro from HealTech Electronics Ltd. is the most advanced gear position
indicator on the market today.
This product will fit all Triumph fuel injected (FI) motorcycles with Keihin ECU.
Unlike other gear indicators available for your bike, this product connects to the
diagnostic connector. It makes the installation very simple. The unit reads data
from the ECU, offering faster and more reliable readings than competitive
products.
The display is auto learning, there are no buttons and no "programming wire".
Known limitation: Triumph motorcycles are not equipped with Gear Position
Sensor, therefore determining the gear in use is only possible when the engine is
running and the clutch is released.
GPDS-T01_Manual_en.pdf
http://www.gi-pro.net
GI
pro DS-series
Installation and Operation Manual
Model GPDS-T01
Rocket III
(2004-2010),
Tiger 1050
[rev. 002]
Speed Triple 1050
Thunderbird
(2007-2010),
(2005-2010),
(2010)
- 1 -

Advertisement

loading

Summary of Contents for HealTech Electronics GIpro DS Series

  • Page 1 Foreword Congratulations on your purchase of a GIpro-DS gear position indicator. The GIpro from HealTech Electronics Ltd. is the most advanced gear position indicator on the market today. This product will fit all Triumph fuel injected (FI) motorcycles with Keihin ECU.
  • Page 2 Installation Find the 16-pole diagnostic connector. It is in a black dust boot, usually near the ECU box. It is an “open” connector, there are no other plugs attached to it. Daytona 650 under seat near battery (2005): Rocket III under seat (2004-2009): Speed Triple 1050...
  • Page 3 Reset If some gears are not indicated correctly, reset the unit and setup it up again. If you have a SpeedoHealer (or other speedometer calibrator) and you change the calibration factor, probably you have to reset the GIpro and set it up again. Cut off the power of the unit 6 times in a row, while the GIpro display is counting up and shows 3, 4 or 5.

This manual is also suitable for:

Gpds-t01