Master Sub Relationship; Automatic Access To Paging - Toa EXES-6000 CP-66 Functions And Operating Instructions

Master Sub Relationship

Master/Substation associations are set up by using station
#200 as the programming station. Once these relationships
have been established, substations can then contact their
designated master stations by simply touch dialing
If TL-600S Handset substation is used, it can be connected
to its designated master station by simply picking up a
handset.
With respect to this function, the stations in the system are
divided into two categories; master stations and substations.
Any master station can be connected to any other station
in the system. However, substations can initiate calls only
to. specific master stations. This is done by single touch
dialing, and will only connect the substation to one specific
master.
Also, one master station can have 2 or more substations.
To register this function, dial
Substation No. paired off with the master
at the master station. This allows the master station to be
connected to the substation when
Note.
Once a certain station number has been desgination as a
substation by No. 200 programming, the single digit
dialing is impossible even when the master station is
connected to that number.

Automatic Access To Paging

This function requires "single digit dialing registration for
handset station" as well as No.200 programming at time of
installation.
A paging call can be placed over the specified zone by
simply lifting the handset.
A paging response is possible by simply lifting the handset.
All manuals and user guides at all-guides.com
Confirmation tone
is pressed.
—72—
Master Station
Handset substation
Single Digit Registration of Substation
Master Station
Substation Number
Paging call
Fig. 1
Paging call
Response to
a paging call
Fig. 2
Tie-line
Substation
Substation
Paging response