Table of Contents
Advertisement
Reference
Function
R64
CAN
R66
CAN
6.7.Oscillator Sources
A crystal oscillator is fitted on the RSK and used to supply the main and sub clock input to the Renesas microcontroller.
Table 6-6: Oscillators / Resonators
details the oscillators that are fitted and alternative footprints provided on this RSK:
6.8.Reset Circuit
The CPU Board includes a simple latch circuit that links the mode selection and reset circuit. This provides an easy method for swapping
the device between Boot Mode, User Boot Mode and User mode. This circuit is not required on customers boards as it is intended for
providing easy evaluation of the operating modes of the device on the RSK. Please refer to the hardware manual for more information
on the requirements of the reset circuit.
The Reset circuit operates by latching the state of the boot switch on pressing the reset button. This control is subsequently used to
modify the mode pin states as required.
The mode pins should change state only while the reset signal is active to avoid possible device damage.
The reset is held in the active state for a fixed period by a pair of resistors and a capacitor. Please check the reset requirements carefully
to ensure the reset circuit on the user's board meets all the reset timing requirements.
Do not use CAN function,
R8C/25 Microcontroller do not
have CAN function
Do not use CAN function,
R8C/25 Microcontroller do not
have CAN function
Table 6-5: Option Links
Component
Crystal (X1)
Fitted
Sub clock (X2)
Fitted
Table 6-6: Oscillators / Resonators
Option Link Settings
Fitted
Alternative (Removed)
Do not use CAN function,
R8C/25 Microcontroller do not
have CAN function
Do not use CAN function,
R8C/25 Microcontroller do not
have CAN function
20 MHz (HC/49U package)
32.768 kHz (90SMX package)
11
Related To
Advertisement
Table of Contents
