Mitsubishi Electric PUHZ-FRP71VHA2 Service Manual page 70

<Function setting>
1
Select "Service" from the Main menu, and press the [
Select "Setting" from the Service menu, and press the [
Select "Function setting", and press the [
2
Set the indoor unit refrigerant addresses and unit numbers with the F1
through F4 buttons, and then press the [
setting.
Note: Checking the indoor unit No.
When the [ ] button is pressed, the target indoor unit will start fan op-
eration. If the unit is common or when running all units, all indoor units
for the selected refrigerant address will start fan operation.
3
When data collection from the indoor units is completed, the current settings
appears highlighted.
Non-highlighted items indicate that no function settings are made.
Screen appearance varies depending on the "Unit No." setting.
4
Use the F1 or F2 button to move the cursor to select the mode number,
and change the setting number with the F3 or F4 button.
5
When the settings are completed, press the [
data from the remote controller to the indoor units.
When the transmission is successfully completed, the screen will return to the
Function setting screen.
Note: • Make the above settings only on Mr. Slim units as necessary.
• The above function settings are not available for the CITY MULTI units.
• Table 1 summarizes the setting options for each mode number. Refer to
the indoor unit Installation Manual for the detailed information about ini-
tial settings, mode numbers, and setting numbers for the indoor units.
• Be sure to write down the settings for all functions if any of the initial
settings has been changed after the completion of installation work.
OCH665B
] button.
] button.
] button.
] button to confirm the current
] button to send the setting
70
Settings menu
Function setting
Service menu:
F1 F2 F3 F4
Function setting
Ref. address
Unit No.
Grp./1/2/3/4/All
Monitor:
Cursor Address
F1 F2 F3 F4
Function setting
Ref. address Grp.
Mode 1
Mode 2
Mode 3
Mode 4
Request:
Cursor Cursor
F1 F2 F3 F4
Function setting
Grp.
Ref. address
Mode 1
Mode 2
Mode 3
Mode 4
Request:
Cursor Cursor
F1 F2 F3 F4
Function setting
Ref. address
Sending data
F1 F2 F3 F4