Function; Before Commissioning - P.Lindberg 9062071 Manual

Function

The wood chipper is designed to chip wood from newly felled trees. Branches should
not be thicker than 10 cm in diameter. Only use the machine for the purpose it is
designed for. The rotor has two blades, each 30 cm in width, and is driven via V-belts
from an engine with an electrical starter. The rotor's centrifugal power ensures that
the woodchip is ejected from the machine's spout. The angle of the rotor's wings
where the blades are securely bolted, and the position of the counter blade ensure
that the branch is automatically pulled into the machine without manual feeding.

Before commissioning

Before use, check that the bolts on the blades and counter blade are secure. After
using for one hour, check that the bolts are still secure and that the distance between
the blades and counter blade is 0.5 mm. If necessary, adjust the counter blade for this
distance.
Check that the positioning of the machine is stable on the ground and make sure that
it cannot tilt in any way. The hazard zone on the output side of the machine must be
respected to avoid serious personal injury when woodchip is ejected from the spout.
Keep bystanders positioned at least 12 m from the machine, and in the opposite
direction to the ejected woodchip.
Make sure the emergency stop works.
Fill with fuel and engine oil according to specifications.
Adjust the chute, so that the processed material is thrown in the optimal direction:
P. Lindberg A/S
Tel.: +45 70212626
Loosen the screws and turn the chute to the
desired position. Tighten again.
10
Sdr. Ringvej 1
6600 Vejen, Denmark
MAN 9062071 EN V4
www.p-lindberg.dk
E-mail: salg@p-lindberg.dk