Page 3
Get to know Zaptec Go Status light Charge card authentication (RFID) Type 2 socket...
Page 4
Included in the box: 3x Sealing cones 2x TX20 2x TX20 1 x Cable clamp 4x TX20 User manual Remove Front Cover...
Page 5
Mount the charging station Make sure it’s level and at an appropriate height. Place the power cable Choose between three entry options (top, back and bottom). Punch out the knockout tab to install from 1 or 2. Each charging station must be protected by a max.
Secure cable Prevent cable from being dislocated by using the cable clamp and screws. Use the sealing cones to make the installation water resistant. Electrical connection Connect all wires and firmly press down all levers as illustrated. Then turn on the circuit breaker to continue. TN 3-phase TN 1-phase IT 3-phase...
Page 7
Configure charging station Scan the QR code with camera and complete the installation in the Zaptec App. It is possible to configure the charging station without using the app, please note there might be limited functionality doing so. Switch is located above the connection terminal.
Page 8
Confirm green light Configuration is completed when the charging station status indicator changes to flashing green and then turns to white status indicator. Mount the Front Cover Secure and lock the front cover.