E-DOC-CTC-20040123-0001 v3.0
•
Select Framebursting to enhance the performance of wireless networks by
improving the efficiency between the client and the wireless access point if you
have mainly downstream traffic i.e. from the SpeedTouch™580.
If selected, it becomes active after you click Apply.
If cleared, it becomes inactive after you click Apply.
•
To disable the SpeedTouch™580 wireless access point:
Proceed as follows:
Deselect wireless interface enabled.
1
All your wireless clients will be disconnected!
Note
Click Apply to apply your changes. The following screen appears:
2
Click
3
Save all
You can also disable your wireless interface by pressing the front panel
Note
button for 10 seconds until the WLAN LED goes off. If these settings
need to be saved on persistent memory, browse to the web pages and
click
Save all
•
To enable the SpeedTouch™580 wireless access point:
Click Enable to enable the wireless interface.
1
The Access Point Settings table is shown
Note
Click
2
Save all
You can also enable your wireless interface by pressing the front panel
Note
button for 10 seconds until the WLAN LED goes on. If these settings
need to be saved on persistent memory, browse to the web pages and
click
Save all
to save your changes.
to save your changes.
to save your changes.
to save your changes.
5 SpeedTouch™ Web Interface
57