THOMSON Speedtouch 580 Setup And User Manual page 101

Wireless multi-user adsl gateway
Hide thumbs Also See for Speedtouch 580:
Table of Contents

Advertisement

E-DOC-CTC-20040123-0001 v3.0
Problem
LAN LED does not light up.
Link integrity/Activity LED of
Ethernet port does not light up.
Poor SpeedTouch™ performance.
SpeedTouch™ is not detected by MS
Windows XP's UPnP™ or Internet
Gateway Device Control Client.
No Line synchronization achieved.
DSL/WAN LED off or flashing.
Bad regular telephone service
Solution
Make sure that the LAN cable are securely
connected to the 10/100Base-T port.
Make sure that you are using the correct
cable type for your Ethernet equipment.
Make sure the computer's Ethernet port is
configured for auto-negotiation.
Make sure that the SpeedTouch™ is installed
and configured as instructed in this Setup and
User's Guide and/or as instructed by the
Service Provider.
Make sure the UPnP™ and Internet Gateway
Device Control Client Networking compo-
nents are added to your MS Windows XP
system.
Your computer doesn't support UPnP™ if
you run an operating system other than MS
Windows XP.
Make sure that UPnP™ is not disabled in the
SpeedTouch™
NAPT
web page.
Check whether the central splitter or dedi-
cated filters are installed correctly and that
the correct line is patched to your Speed-
Touch™ line port.
Make sure that ADSL service is enabled on
the telephone line the SpeedTouch™ is
connected to.
Make sure that the correct SpeedTouch™
variant is used for your DSL service.
In case of ADSL/POTS (ADSL/PSTN) serv-
ices at your premises, ONLY use a Speed-
Touch™ ADSL/POTS variant.
In case of ADSL/ISDN services at your local
premises, ONLY use a SpeedTouch™ ADSL/
ISDN variant.
Check whether a central splitter or dedi-
cated filters are installed properly.
7 Support
99

Advertisement

Table of Contents
loading

Table of Contents