Bunn Ultra NX Installation & Operating Manual page 17

9
9. Pull Hopper forward
to remove.
11
11. Remove the Seal from the
back of the Hopper.
14
14. Wash all parts in a clean sink
with mild soap and hot water
(120°F).
CLEANING
10
10. Remove Auger Nose Bushing
from inside the Hopper.
12
12. Pull Auger from
Cooling Drum.
15
15. Place all parts in a clean sink
with *Sanitizer Solution.
Allow all parts to soak for at
least 5 minutes.
*Sanitizer Options
Chlorine Sanitizers: 1 packet of KAY-5
ingredients) into 2.5 gallons (9.46L) of minimum 80˚F (26.6˚C) water
to ensure 100 ppm chlorine.
17
NOTE: Care must be taken to
ensure this surface does not get
scratched during cleaning. Deep
scratches could cause leakage
around the Seal.
13
13. Pull Grommet from
Cooling Drum.
16
16. Carefully wash all components
with a clean wash cloth in
the hot water and *Sanitizer
Solution. Use a clean, soft,
bristle brush as needed for
the smaller components and
tight areas.
NOTE: Do not immerse
Hopper Lids and use a
commercial sanitizer.
sanitizer (or equivalent active
®
continued >