Receiving The Product; Transporting The Product; Inspecting The Product; Mechanical Installation - Grundfos SMD Installation And Operating Instructions Manual

4. Receiving the product

4.1 Transporting the product

The individual components of the mixer or flowmaker
must be packed carefully to prevent any damage to
the surface protection during transportation.
Make sure that the mixer, flowmaker and
accessories cannot roll or fall over.
Before lifting the components, make sure
to comply with any local regulations that
set limits for the weights to be lifted man-
ually by individuals.
All lifting equipment must be rated for the
purpose and checked for damage before
lifting the components. The lifting equip-
ment rating must under no circumstances
be exceeded.

4.2 Inspecting the product

Do not install a damaged mixer or flow-
maker.
Check the product and the accessories for any visible
damage upon delivery.
If the product or the accessories are damaged,
contact Grundfos immediately. Do not remove a
damaged component, unless instructed otherwise by
Grundfos.
Make sure to comply with local regulations when
disposing of the package.

5. Mechanical installation

5.1 Foundation

Lift the mixer or flowmaker by the suspension
point. See figs Mounting the lifting wire on the motor
bracket and Mounting the lifting wire on SMD.
Mounting the lifting wire on the motor bracket
Mounting the lifting wire on SMD
Do not use the lifting equipment supplied
with the unit nor the wire used for lifting
and lowering the mixer or flowmaker into
the tank as universal lifting equipment.
Never hang the mixer or flowmaker by the
power cable. Never let the mixer or flow-
maker run while hanging from the lifting
equipment.
13