Related Manuals for Grundfos AMG Series
Summary of Contents for Grundfos AMG Series
- Page 1 GRUNDFOS INSTRUCTIONS 50/60 Hz Service instructions Installation and operating instructions in English and other languages for 50/60 Hz. http://net.grundfos.com/qr/i/96498078...
-
Page 3: Table Of Contents
4.4 Sectional drawings 1.2 Notes Read this document before starting service work on The symbols and notes below may appear in Grundfos the product. Installation and service work must installation and operating instructions, safety instructions and comply with local regulations and accepted codes of service instructions. -
Page 4: Safety
1.3 Safety 2. Preparing the dismantling of the product Installation of products in pits must be carried out by 2.1 Transporting the product specially trained persons. Transport the product in horizontal position. Make sure the Work in or near pits must be carried out according to product cannot roll of fall over. -
Page 5: Dismantling And Assembling The Product
Make sure that the power supply cannot be accidentally switched on. Maintenance and service work on explosion-proof - Disconnect the power cable in accordance with products must be carried out by Grundfos or a local regulations. service workshop authorised by Grundfos. WARNING 3.3.1 Removing the propeller... - Page 6 3.3.3 Removing the gear casing 3.3.6 Removing the motor 1. Cut with a knife between the motor flange (1020) and the gear 1. Place the motor in vertical position with the shaft upwards. housing (1088) to protect the paint. 2. Remove the gear head. See section 3.3.3 Removing the gear 2.
-
Page 7: Assembling The Product
10. Lubricate the groove for the O-ring (1022) on the gear side of Maintenance and service work on explosion-proof the motor flange (1020). products must be carried out by Grundfos or a 11. Fit and lubricate the O-ring (1022). service workshop authorised by Grundfos. - Page 8 3.4.2 Fitting the cable 3.4.4 Fitting the gear casing 7. Place the motor in horizontal position. 8. Fit the cable flange (1002) and the O-ring (1007) on the cable Lubricate and tighten the screws and nuts according (1001). to section 4.3 Torques and lubricants. 9.
- Page 9 3.4.5 Fitting the sealing system of propeller hub and gear casing Lubricate and tighten the screws and nuts according to section 4.3 Torques and lubricants. 1. Lubricate the wear ring (1097) and place it in the propeller end of the gear casing (1088). Press home with special tool (D). 2.
-
Page 10: Additional Information
95035454 TMFS12 KM12 AMG.150-185 95035456 Bearing (inner) 1092 Bearing fitting TMFT 36 97905585 tool Bearing (outer) 1094 Special tool Wear ring 1097 Shaft seal (stationary part) Contact Special tool 1098 Grundfos Shaft seal (rotating part) Special tool Lip seal 1104... -
Page 11: Torques And Lubricants
4.3 Torques and lubricants Torque Pos. Lubricant Description Range Quantity Dimension [Nm] [ft-lbs] 21.4 15.8 1008 32.5 Loctite 243 Screw 54.6 135.0 1020 Curil K2 Motor flange 1021 By hand Screw 158.42 x 2.62 AMG.15 - AMG 40 1022 Curil K2 O-ring 215.57 x 2.62 AMG.55 - AMG.185... -
Page 12: Sectional Drawings
4.4 Sectional drawings 4.4.1 Standard products AMG.20-55 [ANSI] and AMG.15-40 [DIN]... - Page 13 AMG.75-150 [ANSI] and AMG.55-110 [DIN]...
- Page 14 AMG.200-250 [ANSI] and AMG.150-185 [DIN]...
- Page 15 4.4.2 Explosion-proof products AMG.15-AMG.40 [DIN - 50 Hz]...
- Page 16 AMG.55-AMG.110 [DIN - 50 Hz]...
- Page 17 AMG.150-AMG.185 [DIN - 50 Hz]...
- Page 18 4.4.3 Components and material specification DIN W.-Nr. / DIN W.-Nr. / Pos. Component Material AISI/ASTM Pos. Component Material AISI/ASTM EN standard EN standard Connection for Nickel-plated 1001 Cable CPE (rubber) 1053* protective earthing brass Cast iron/ EN-GJL250/ A48 class 1002 Cable flange 1054 Lower lip seal 1070/1090 Stainless steel...
- Page 22 220125, Минск GRUNDFOS GMBH Mexico ул. Шафарнянская, 11, оф. 56, БЦ «Порт» Schlüterstr. 33 Bombas GRUNDFOS de México S.A. de C.V. Тел.: +7 (375 17) 286 39 72/73 40699 Erkrath Boulevard TLC No. 15 Факс: +7 (375 17) 286 39 71 Tel.: +49-(0) 211 929 69-0...
- Page 23 92 Chaloem Phrakiat Rama 9 Road, Dokmai, Pravej, Bangkok 10250 Phone: +66-2-725 8999 Telefax: +66-2-725 8998 Turkey GRUNDFOS POMPA San. ve Tic. Ltd. Sti. Gebze Organize Sanayi Bölgesi Ihsan dede Caddesi, 2. yol 200. Sokak No. 204 41490 Gebze/ Kocaeli...
- Page 24 97908898 0418 ECM: 1229541 www.grundfos.com www.grundfos.us...