Receiving The Product; Installing The Product; Starting Up The Product; Servicing The Product - Grundfos SMD Series Installation And Operating Instructions Manual

3.4 Receiving the product

Make sure that the mixer or flowmaker cannot roll or
fall over.
Before attempting to lift or otherwise handle the
individual components of the mixer or flowmaker,
observe any local regulations that set limits for the
weight of components to be lifted manually by
individuals, i.e. handled without the use of lifting
equipment.

3.5 Installing the product

DANGER
Electric shock
Death or serious personal injury
- Make sure the power supply to the control cabinet
has been switched off.
DANGER
Electric shock
Death or serious personal injury
- Before making any electrical connections, make
sure that the fuses have been removed or the main
switch has been switched off. Make sure that the
power supply cannot accidentally be switched on.

3.6 Starting up the product

DANGER
Electric shock
Death or serious personal injury
- When adjusting the relay, beware of electric
voltage.
CAUTION
Pressurized system
Minor or moderate personal injury
- As pressure may have built up in the oil chamber,
do not remove the oil level screw until the pressure
has been fully relieved.
Make sure that no persons can fall into the tank.

3.7 Servicing the product

Before starting work on the mixer or flowmaker,
– make sure that the fuses have been removed or
the main switch has been switched off
– make sure that the power supply cannot
accidentally be switched on
– make sure all rotating parts have stopped
moving.
CAUTION
Biological hazard
Minor or moderate personal injury
- Flush the mixer or flowmaker thoroughly with clean
water and rinse the mixer or flowmaker parts in
water after dismantling.
CAUTION
Pressurised system
Minor or moderate personal injury
- As pressure may have built up in the oil chamber,
do not remove the oil level screw until the pressure
has been fully relieved.

3.8 Fault finding the product

Before starting work on the mixer or flowmaker,
– make sure that the fuses have been removed or
the main switch has been switched off
– make sure that the power supply cannot
accidentally be switched on
– make sure all rotating parts have stopped
moving.
5