Hardware Description; Front Panel; Rear Panel - Planet MGSW-2402 User Manual

This product series provide three different running speed – 10Mbps, 100Mbps, and 1000Mbps in
the same switch and automatically distinguish the speed of incoming connection.
This section describes the hardware features of these Switches. For easier management and
control of the switch, familiarize yourself with its display indicators, and ports. Front panel
illustrations in this chapter display the unit LED indicators. Before connecting any network device
to the switch, read this chapter carefully
There are following option module for expansion:
8-Port 10/100 auto-sensing Intelligent Switch Module
4-Port 100 Base-FX Intelligent Fiber Module
Gigabit 1000Base-T Intelligent Switch Module
Gigabit 1000Base-SX/LX Intelligent Fiber Module

2.1 Front Panel

The Front Panel of the MGSW-2402 Intelligent Switch consists of 24x auto-sensing 10/100Mbps
Ethernet RJ-45 Ports, two optional expansion slots, and Console port. The LED Indicators are
also located on the front panel of the Switch.
LED indicators
MGSW-2402
PWR
Diag.
100
LNK/ACT
FDX/ COL

2.2 Rear Panel

The rear panel of the Switch indicates an AC inlet power socket and an on/off switch which
accepts input power from 100 to 240VAC, 50-60Hz.
MGSW-2402 Switch front panel
Green Lit on: Power on
Lit off: power off
Red Lit on: Alert and problem notice
Green Lit on: the port run at 100Mbps
Lit off: the port run at 10Mbps
Green Lit on: the connection is good.
Blink: The port is receiving or transmitting data
Yellow Lit on: the port run at full-duplex
Blink: Half-Duplex/ Collision
Off: Half-duplex or not connected
MGSW-2402 Switch rear panel

2. HARDWARE DESCRIPTION

- 6 -