Using This Unit With A Pioneer Plasma; Display; Using The Sr+ Mode With A Pioneer Plasma Display - Pioneer S-DV535 Operating Instructions Manual

Other connections
Using this unit with a Pioneer
plasma display
If you have a Pioneer plasma display (models
PDP-504HDG and PDP-434HDG), you can use
1
an SR+ cable to connect it to this unit and
take advantage of various convenient features,
such as automatic video input switching of the
plasma display when the input is changed.
Media receiver
CONTROL
OUT
Pioneer plasma display
OPTICAL IN
IN
AUDIO
CONTROL
LINE 2
ANTENNA
COMPONENT
VIDEO OUT
Y
P
B
P
VIDEO R
S-VIDEO
OUT
OUT
VIDEO
• Use a 3-ringed miniplug SR+ cable to
connect the CONTROL IN jack of this unit
through a media receiver to the CONTROL
OUT jack of your plasma display.
Before you can use the extra SR+ features, you
need to make a few settings in the unit. See
SR+ Setup for Pioneer plasma displays on
page 23 for detailed instructions.
Note
1 The 3-ringed SR+ cable from Pioneer is commercially available under the part number ADE7095. Contact the Pioneer Cus-
tomer Support division for more information on obtaining an SR+ cable.
2 You won't be able to use the remote sensor of this unit with the CONTROL IN jack of this unit connected to the CONTROL
OUT jack of your plasma display. You can use the remote sensor of the plasma display (even in standby) as long as the power
isn't switched off.
3 The automatic volume muting feature is enabled separately; see SR+ Setup for Pioneer plasma displays on page 23.
4 If you disconnect the SR+ cable or switch the plasma display off while SR+ is on, the setting automatically reverts to SR+
OFF. This displays an error if you switch the input of the unit with the plasma display switched off. Likewise, if this unit is switched
off, the link with the plasma display will be terminated.
XV-DV535
FM
AM
UNBAL 75Ω
LOOP ANTENNA
2
Using the SR+ mode with a Pioneer
plasma display
When connected using an SR+ cable, a
number of features (such as automatic video
input switching and volume muting
plasma display) become available to make
using this unit with your Pioneer plasma
display even easier.
See also SR+ Setup for Pioneer plasma displays
on page 23 for information on setting up the
unit.
1 Make sure that the plasma display and
this unit are switched on and that they are
connected with an SR+ cable.
See Using this unit with a Pioneer plasma
display above for more on connecting these
components.
2 Press SR+ on the remote.
3 When you see 'Setup?' appear in the
display, use to select ' SR+ On' or ' SR+
Off' .
• If SR+ Error shows in the display, it means
there is a communication problem
between the unit and the plasma display.
Check all connections and retry.
08
3
on the
4
33
En